Bogen PM-3000 Manuel d'utilisateur télécharger pdf (Page 30)

Programming

5. Select a level and press ENT to save the selection (PROG LED will

blink when selection has been entered).

Important: You must press ENT after every change you make

in order to save the new setting. This is true for all program-

ming procedures.

6. Repeat Step 3, 4 and 5 to assign any other inputs to the amplifier chan-

nel. Note that priority level numbers become unavailable from the selec-

tion list as they are assigned to a particular input.

Note: Priority levels do not need to be assigned consecutively.

For example, an installer could assign only 2 inputs to an ampli-

fier channel and give one the highest priority (1) and the other

the lowest (6). If the priority 1 input went inactive, the amplifier

would switch to the input with the next lowest priority (6). At

least one input source must be assigned to each amp channel

for proper operation.

7. Once you have finished assigning priorities for one amplifier, you can

press a different AMP button and proceed to program inputs for this

amplifier channel.

8. To exit the function, press EXIT. The display will again show ASSIGNMENT.

9. Press the NEXT or BACK buttons to scroll through the function menu or

press EXIT to return to users mode.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 48 49

Pas de commentaire

Bogen PM-3000 Manuel d'utilisateur Page 30