Bogen PM-3000 Manuel d'utilisateur télécharger pdf (Page 36)

Programming

6. Once you have set the desired limit for an input, press ENT. The

PROG light will blink to indicate that data was stored.

7. Select another amp/channel-input combination and repeat Steps 4 and

5 to set other levels. Remember to press ENT after setting each

level.

8. Once all levels are set, press EXIT to return to the function menu. At

this point you can exit the programming mode or press the NEXT/BACK

buttons to select another function.

Note 1: If the Volume Limit is set below the Preset volume

level, the Volume Limit will control the power on output level.

Note 2: Unassigned inputs for an amp can still have their

Volume Limit set. This is allowed since an input can be manu-

ally selected even if it is not assigned a priority level.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 48 49

Pas de commentaire

Bogen PM-3000 Manuel d'utilisateur Page 36